Page 1 of 1
wiper motor
Posted: Fri Dec 09, 2005 9:36 pm
by Gene-C
The problem I have is that the buggy I just purchaced is drilled out to accept a wiper assembly. The wiper assembly I tryed to put in is out of 68 and the holes are about a half inch to wide. Is their different widths of wiper assemblies for different years. Or will I have to fill in with glass and redrill.
Posted: Fri Dec 09, 2005 10:10 pm
by manxdavid
Maybe slot the holes with a file and grind some 1/2" washers to an oval shape to cover the gap?
Posted: Sat Dec 10, 2005 12:43 am
by desbuggy
I found the same thing with the buggy that I picked up. My thought was to cut the wiper bracket mechanism and weld in a spacer to make it the correct width. I haven't tried it yet but it should work.