Head or cylinder shims?
-
- Posts: 29
- Joined: Wed Nov 17, 2010 6:00 am
Head or cylinder shims?
[FONT=Verdana]I'm starting to reassemble my 1835 cc engine which had a set of cylinder-to-case shims installed before. They seemed to work fine before but were a little messy to install using RTV sealant. I have a new set of them but also have a set of copper head-to-cylinder shims of the same thickness. Which are the best to use? Do the copper shims seal better? Any personal experience out there? Thanks.[/FONT]