Piston weight and position on engine
Posted: Fri Dec 15, 2017 11:32 am
Hi,
I am not very trusting of the food/postal scale, which does not seem to have the accuracy that I would trust in removing material, so hence the question. Should I grind to get them spot on or would I gain enough to take the time/chance? I have put many engines, air cooled small engines and water cooled automobile engines together but this is my first "Performance" engine.
Or should I grind to remove weight? Which then leads to the question of where to remove the weight?
I didn't find the right solution from the internet.
References: http://www.dunebuggyarchives.com/forum/ ... l?tid=5331
Corporate Promotional Animation
I am not very trusting of the food/postal scale, which does not seem to have the accuracy that I would trust in removing material, so hence the question. Should I grind to get them spot on or would I gain enough to take the time/chance? I have put many engines, air cooled small engines and water cooled automobile engines together but this is my first "Performance" engine.
Or should I grind to remove weight? Which then leads to the question of where to remove the weight?
I didn't find the right solution from the internet.
References: http://www.dunebuggyarchives.com/forum/ ... l?tid=5331
Corporate Promotional Animation