Manx Club

Currently have Kadron's on my raised engine Buggy and they barley fit. Looking at a motor with duel 44's for the stock Manx? Do they fit and if so what manifolds....Thanks

I have a clone body not a Manx. At one time, I had Kadrons on it and they set higher than the Weber 40's I have on it now. I used the manifolds that come with the Weber Redline 40 Kit.

Gene Berg's IDF/DRLA manifolds are 4in tall measured from the valve cover rail (place valve cover fits over). They are what I used for clearance on my Kick Out. Manifolds for type III engines are even shorter, but require some fabrication for clearance of linkage on some applications.

Yes was thinking of manifolds for square backs good to know about Berg no idea were to get them. Empi has a low duel carb mamifolds? Are there carbs ok? I find new is always better with carbs.

langan wrote: ↑Wed Feb 18, 2015 5:18 am Currently have Kadron's on my raised engine Buggy and they barley fit. Looking at a motor with duel 44's for the stock Manx? Do they fit and if so what manifolds....Thanks

Okay