Show us your dune buggies! Empi Imps, Bounty Hunters, Funco Wampuskitties, Veeps, Hooker Wallabugs, Llamas, home builts, etc. Good ole buggies!
langan
Posts: 242 Joined: Sun Mar 09, 2014 6:00 am
Location: Eagle ID.
Post
by langan » Mon Sep 14, 2015 9:20 pm
Motor is in and running pretty good. Still no exhaust but jetting real close. Trans needs to go back will not shift into 2nd. Trans guy being real good so far. Also going to make it a frywayflyer style. Turns out the used one I set car up with was one. So as wheater turns to cold I can take apart and paint.
langan
Posts: 242 Joined: Sun Mar 09, 2014 6:00 am
Location: Eagle ID.
Post
by langan » Tue Sep 22, 2015 3:26 am
My youngest out Cruzin with his gal in the buggy. Said it does nice doughnuts
Jon
Posts: 131 Joined: Thu Mar 24, 2011 5:00 am
Post
by Jon » Mon Sep 28, 2015 1:17 pm
Great looking buggy. How tall is that windscreen? I've got one at 12 inches and yours look a whole lot lower.
Sent from my iPhone using Tapatalk
langan
Posts: 242 Joined: Sun Mar 09, 2014 6:00 am
Location: Eagle ID.
Post
by langan » Sat Oct 31, 2015 6:32 am
10" I want to raise it but lost the pieces I cut out. I do think 12" is better let's see yours?
langan
Posts: 242 Joined: Sun Mar 09, 2014 6:00 am
Location: Eagle ID.
Post
by langan » Sat Oct 31, 2015 6:48 am
New carbs 48idf,new Berg manifolds and new linkage. After 3 tries I like this setup best. Kadrons were not good for me. The 48idf on the type3's was ok but I had modified Kadron linkage and I could here gas gurgling when hot.
langan
Posts: 242 Joined: Sun Mar 09, 2014 6:00 am
Location: Eagle ID.
Post
by langan » Sun Feb 28, 2016 1:14 am
New exhaust almost done.
langan
Posts: 242 Joined: Sun Mar 09, 2014 6:00 am
Location: Eagle ID.
Post
by langan » Tue Mar 08, 2016 5:35 am
A little paint and I can drive again
langan
Posts: 242 Joined: Sun Mar 09, 2014 6:00 am
Location: Eagle ID.
Post
by langan » Thu Mar 10, 2016 5:58 am
Done and ready to play again
langan
Posts: 242 Joined: Sun Mar 09, 2014 6:00 am
Location: Eagle ID.
Post
by langan » Fri Mar 11, 2016 4:22 am
It is way happier with correct size exhaust. It was choked off with 1.375 ID tubing and 1.5 ports.