Manx Club

Still working on it. I have driven it Hope to have ready for some west coast club events. If I can figure out picture posts I will post.
I was told at Big Bear this site works better?

Welcome. If you are looking to post pictures here, go to this thread;

http://www.manxclub.com/forum/viewtopic.php?f=64&t=3419

Welcome.

Ready for paint

Made a SS exhaust. Shinny but to noise will make a new muffler. Old exhaust went to yellow car in Calif. One car will make Big Bear

That's some pretty nice stuff right there. Very creative.

Low down got a trunk not sure I like but very handy

JJLangan wrote:Low down got a trunk not sure I like but very handy

Once again you have demonstrated some excellent design and fabrication skills. Outstanding sir!

Got 2nd place People's choise. I think all the kids voted. Best clown car..Ha

Thanks Bud

Got rid of the Kadron's ... Kadie Shack was great but never got them working. So had the 40's on a 2054 and they were to small for it. Got a pair of type 3 manifolds and a little trickery on Kadron linkage and now car is way better. Wanted to use the Berg manifolds but they wer to tall.old carbs fit good too

Thanks for the nice words. The mid engined honda may get cut up and turned into a Manx

Got new trans and new motor going in 2180 with 48's need to make another exhaust. So the fun goes on.